Alliance Laundry Systems UW35S2, Operating And Programming Manual

Page: 16 / 94

Operation
14
F232087
flushes supplies from the cups with water
when called for in the cycle program.Theory
Of Operation (Continued)
Liquid supplies can be injected directly into
the cups by a customer-supplied external
chemical supply system. Five hose strain
reliefs on top of the supply dispenser facilitate
connection to an external supply system. A
terminal strip inside a compartment attached to
the left side of the control module, viewed
from the rear of the washer-extractor, provides
connection points for external supply signals.
S-Computer
The S-computer control is a programmable
solid-state control capable of storing and
running up to 30 cycles. A detailed description
of the 12 preprogrammed cycles can be found
in the Programming section of this manual
under S-Computer Standard Cycles.
If this machine’s computer has been equipped
with special preprogrammed cycles, a separate
insert listing these cycles has been included in
the resealable plastic bag which contained
this manual.
Note: Never turn the power off while the
computer mode switch is in the PROGRAM
position. Such action will disorder portions of
the programmed data, necessitating
reprogramming of some or all of the existing
cycles. Always return the mode switch to RUN
position before turning the power off.
Keypad
Operation of the S-computer control is
performed with a 4-key touch keypad and LED
display located on the front of the machine.
See Figure 2–2. The following table describes
the function of the individual keys when the
machine is in RUN mode.
Figure 2–3
Keypad
Key Description
Up
Used in cycle selection; pressing this key
moves among cycles from smaller to greater.
Down
Used in cycle selection; pressing this key
moves among cycles from greater to smaller.
Start
Used to start a cycle.
Stop
Used to stop a cycle.
LED Display
MC004B