Alliance Laundry Systems SWD447C, Installation & Operation Manual

Page: 26 / 144

Installation
801539
24 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Step 8: Position and Level the Unit
Place unit in position on a solid, sturdy and level floor.
Installing the unit on any type of carpeting, soft tile,
pedestal, a platform or other weakly supported
structures is not recommended.
Loosen 7/8 inch locknut and adjust the front and rear
leveling legs until the unit is level from side to side and
front to back (using a level). Unit should not rock.
NOTE: Level must rest on raised portion of top
panel. Refer to Figure 13.
Tighten the locknuts securely against the unit base
using the 7/8 inch wrench. If the locknuts are not tight,
unit will move out of position during operation.
NOTE: DO NOT slide unit more than four feet
across floor if the leveling legs have been extended,
as legs and base could become damaged.
NOTE: Use of the dispenser drawer or washer or
dryer doors as handles in the transportation of the
unit may cause damage to the dispenser or doors.
Remove rubber feet from accessories bag and place on
all four leveling legs.
NOTE: For further assistance, refer to section on
Location Requirements.
Verify that unit does not rock.
Figure 13
Units elevated above floor level must be
anchored to that elevated surface, base or
platform. The material used to elevate the
unit should also be anchored to the floor to
ensure that the unit will not walk or that the
unit can not be physically pulled, tipped or
slid from its installed position. Failure to do
so may result in conditions which can
produce serious injury, death and/or
property damage.
W307
WARNING
SWD746N
1 Leveling Leg
2 Unit Base
3 Level
4 Locknut
5 Rubber Foot
SWD746N
3
2
1
4
5