Washer Symptom
Possible/Cause Solution
Control not responding to keypad selections
• Make sure Control Lock feature is off. If on, Control Lock light
will be lit.
• Press and hold Signal Keypad for three seconds to turn off.
Er, do on digital display
• The control senses that the door is open during a running cycle.
• Unplug the machine to clear this code.
Er, dL on digital display
• The control senses that the door has unlocked during a running
cycle.
• Unplug the machine to clear this code.
Er, dr on digital display
• This code indicates that water is still in the washer at the end
of the cycle.
• Check the drain hose and drain receptacle to make sure they
are installed properly and not blocked.
• Foreign object trap in pump may be clogged. Clean the trap. Re-
fer to Maintenance section.
• Unplug the machine for 15 seconds to clear this code.
Er, FL on digital display
• This code will appear if the washer has not reached the fill level
after 30 minutes during a wash or rinse fill.
• Make sure hot and cold water faucets are turned on.
• Make sure that the fill hoses are not kinked or twisted.
• Clean the screens in the water mixing valve and the filter
screens located at the faucet end of the fill hoses.
• Unplug the machine for 15 seconds to clear this code.
Er, nF on digital display
• The washer has not filled to the proper water level.
• No or very little change in water level has been sensed within 5
minutes of the current fill.
• Make sure hot and cold water faucets are turned on.
• Make sure that the fill hoses are not kinked or twisted.
• Clean the screens in the water mixing valve and the filter
screens located at the faucet end of the fill hoses.
• Unplug the machine for 15 seconds to clear this code.
Er, OF on digital display
• This code indicates the washer has filled to the overflow level.
• The machine will begin to attempt to pump water out if the
door is closed and locked.
• Foreign object trap in pump may be clogged. Clean the trap. Re-
fer to Maintenance section.
• If the code does not clear, unplug the machine and call for serv-
ice.
Er, PS on digital display
• The control has detected trouble sensing the water fill level.
• Unplug the machine and call for service.
Er, dU on digital display
• The control senses that the door will not unlock.
• Unplug the machine for three minutes to unlock the door.
• If the code appears again, call for service.
Troubleshooting
Part No. 804648R3
©
Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
23
