53264
45
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
63. REAR BULKHEAD AND HEATER BOX
a. Remove front panel. Refer to Paragraph 31,
steps “a” through “c”.
b. Remove cylinder assembly. Refer to Paragraph
60, steps “b” through “e”.
c. Gas Models –Remove burner housing. Refer to
Paragraph 32, steps “b” through “j”.
d. Gas Models–Remove four hex head screws
holding heat shroud to heater box. Refer to
Figure 16. Remove shroud out through front of
dryer.
e. Electric Models–Remove two hex head screws
holding element and plate to heater box. Pull
element down and away from heater box. Refer
to Figure 25.
f. Electric Models – Disconnect wires from
element terminals and from high limit
thermostat.
NOTE: When reassembling, be sure all wire
connections are tight on element terminals and to
high limit thermostat.
g. Remove two hex head screws holding heater
box to heat shield. Refer to Figure 37.
h. Remove one Phillips head screws holding rear
bulkhead to terminal block bracket. While
supporting bulkhead, remove the four Phillips
head screws holding rear bulkhead to mounting
brackets. Refer to Figure 37. Lift complete
assembly out of dryer.
TO REMOVE HEATER BOX FROM REAR
BULKHEAD
a. Refer to Figure 39 for removal.
Figure 38
DRY865S
SHAFT
SPACER
WASHER
WASHER
RETAINER
RING
ROLLER
Figure 39
DRY866S
REAR
BULKHEAD
HEATER BOX
ATTACHING
SCREWS
