Alliance Laundry Systems F232122R3, Supplement Manual

Page: 22 / 64

Installation
F232122
20
e. Remove the four bolts from each tank located
behind cap plug at each corner. Refer to
Figure 9 .
f. Lift tanks off the washer-extractor.
2. Removing the pump assembly:
a. Remove manifold hose clamps connecting the
pump manifold to the drain valve found at the
rear of the washer-extractor to the right of the
pump assembly. Refer to
Figure 9 .
b. Unscrew the two pump motor electrical quick
disconnects from the water saving control
housing located at the rear of the washer-
extractor.
c. Slide off the long black hoses that run from
the water tanks. Refer to Figure 9 .
d. Remove pump assembly and place to the side.
3. Positioning and bolting down the washer-
extractor:
Refer to Mechanical Installation Section for
boltdown instructions.
Figure 9
Be extremely careful when removing tanks.
To prevent damage, always place tanks on a
level surface with clean-out access facing
up.
CAUTION
Q008I
1 Corner Tank Bolts (4 per Tank) 4 Pump Assembly
2 Hose Clamps on Elbows 5 Cap Plug
3 Manifold Hose Clamps
Q008I
3
2
1
4
5