Alliance Laundry Systems 800797, Installation Instructions Manual

Page: 10 / 34

800797
8
Step 4:
Position and Level the Washer
Place washer in position on a clean, firm and
reasonably level floor. Installing the washer on any
type of carpeting is not recommended.
Loosen 7/8" locknut and adjust the front and rear
leveling legs until the washer is level from side to side
and front to back (using a level). Washer should not
rock.
NOTE: Level must rest on raised portion of top
panel. See illustration.
Tighten the locknuts securely against the washer
base
using the 7/8" wrench. If the locknuts are not
tight, washer will move out of position during
operation.
NOTE: DO NOT slide washer across floor if the
leveling legs have been extended, as legs and base
could become damaged.
NOTE: Use of the dispenser drawer or washer door
as a handle in the transportation of the washer may
cause damage to the dispenser or door.
Remove rubber feet from accessories bag and place on
all four leveling legs.
Washers elevated above floor level must
be anchored to that elevated surface, base
or platform. The material used to elevate
the washer should also be anchored to the
floor to ensure that the washer will not
walk or that the washer can not be
physically pulled, tipped or slid from its
installed position. Failure to do so may
result in conditions which can produce
serious injury, death and/or property
damage.
W306
WARNING