25
Engine stop switch
Using a spanner loosen the throttle
cable clamp on the engine. Pull the
throttle cable through the clamp
until the throttle arm makes contact
with the stop switch. Tighten the
cable clamp.
Set the throttle in the Stop position
Throttle arm
7.16 Adjusting the rear roller scraper
Make the mower SAFE then proceed as follows:
Tools required:
10mm spanner x2
7.17 Engine stop adjustment
For the engine to stop the throttle arm must make contact with the stop switch. If
adjustments are necessary make the mower SAFE then proceed as follows:
Tools required:
8mm spanner
Using a pair of spanners loosen the rear roller scraper
fasteners. Then move the scraper nearer or further from
the roller.
Should the scraper not be required position it in the
furthest position from the roller - do not remove it, it
adds strength to the roller assembly
