17
With the blade engagement lever pulled back, make sure the centre of the screw
head is aligned with the
‘run’ mark as shown below:
Release the blade engagement lever, make sure the centre of the screw head is in
the brake zone as shown below:
If necessary, to apply more force to the clutch proceed as follows:
Tools required:
17mm spanner x 2
Using a spanner loosen the lock nut.
Move the adjuster DOWN in the direction shown.
Make adjustments in small increments until the screw
head is aligned with the ‘run’ mark on the clutch.
Brake Zone
Brake
Run
23kg (50Lbs) pull from spring
✓
‘run’
mark
Brake
