Sprayer Assembly
Assembly of Power Sprayer to a barrel.
1. Using the barrel hold down bar (
A
) and the three hold down rods (
B
) supplied, fasten the barrel(s)
down to the trailer.
NOTE
: If the hold down bar is not in use it can be fastened to the trailer, use the
two holes on the top left side of the trailer.
2. After the barrel(s) are fastened to the trailer, take the OD 1.05” x ID 0.75” suction tube (
C
) and the
filter (
D
) and fasten then together. Then, take the 5’ X 3/4” hose (
E
) that is supplied and fasten
them together. Put the suction tube in the larger hole of the barrel. Connect opposite end of suction
hose to the 3/4” QDC connector located on the pump.
3. Take the OD 1.05” x ID 0.824” bypass tube (
F
) and the 5’ X 1/2” hose (
G
) that is supplied and
fasten them together. Put the bypass tube in the smaller hole of the barrel. Connect opposite end
of the bypass hose to the 1/2” QDC connector on the pump located directly above the flow control
valves. See Figure 2.5 page 31.
4. Locate the spray gun hose (
H
). Connect the end of the hose to the spray gun (
I
).
[G]
[E]
[D]
[F]
[A]
[E]
[B]
[D]
[C]
[G]
[H]
Figure 2.1: Barrel Assembly
[C]
SECTION 2
OPERATIONS
075770
Page 27
Summary of Contents for MPS9910
