allen AW16-H, Safety & Operation Manual, Page: 60 / 78

22
33 32
12
21
27
8
18
28
23
24
RETURN BUCKET DUMP BUCKET
30
25
15
24
23
13
26
29
CUT ONE SIDE OF RUBBER BUS
HING THRU AND INSTALL CABLE
22.
IN THE TOP OF
CONSOLE #42100-38 TO THE
RIGHT OF REAR WHEEL
STEERING ASSEBMBLY.
MOUNT LOOM CLAMP ON CA
RBURETOR STUD TO RETAIN
CABLE.
3.6 - Dump Lever Adjustment, continued
J. Place a 5/8”NF-18 jam nut on the threaded end of the bulkhead fitting protruding through each mounting
hole.
K. Attach a clevis to each end of the cable.
Note: In all cases the cable attachments must be threaded onto the ¼”NF-28 cable end one-quarter of an inch(¼”). After
each attachment is threaded onto the cable end its position must be secured by tightening the jam nut (item 24) against
the clevis.
L. Then attach the cable end clevises to the handle mounted dump control lever (items 14 and 18) and the
dump valve connecting link bar (item 13) using the Clevis Pins. Secure the clevis pins in the clevises with
NEW 3/32”(.093”) diameter x 3/4” long plated cotter pins. Do not reuse cotter pins.
M. Tighten the two (2) 5/8”NF-18 jam nuts on the cable bulkhead fitting at the mounting hole located at the
dump valve connecting link bar. Adjust and tighten the nuts so that dump valve connecting link bar (item
13) is in the vertical position.
N. Tighten the two(2) 5/8”NF-18 jam nuts on the cable bulkhead fitting on the handlebar. Adjust the nuts so
the handlebar mounted dump handle is in the vertical position.
SECTION 3
SERVICE
055838 Page 60