allen 068344, Safety & Operation Manual

Page: 28 / 44

SECTION 2
OPERATION
068521 Page 28
Fuel Conversion, Gas / LP
To Run Engine On Propane:
1. Prior to operation on gaseous fuel, make sure carburetor is emptied of all gaso-
line. If engine has previously ran on gasoline, turn “Gasoline Fuel Shut-Off Valve”
(5) to the “OFF” position and let engine run out of fuel.
2. Connect propane fuel supply to the “Gaseous Fuel Regulator” (12)
3. Verify the “Gaseous Fuel Selector Valve” (8) is in the “Hori-
zontal” position
4. Open the valve on the propane tank to allow gas to pass to
the engine
5. Turn the “Engine ON/OFF Switch (if equipped)” to the “ON”
position.
6. Pull the “Recoil Starter (pull rope)” (4) to start the engine.
7. Use the “Choke Lever” (6) as needed.
To Run Engine On Gasoline:
1. Make sure gaseous fuel supply is not connected to the “Gaseous Fuel Regulator”
(12)
2. Turn the “Gasoline Fuel Shut-Off Valve” (5) to the “ON” position
3. Turn the “Engine ON/OFF Switch (if equipped)” to the “ON” position.
4. Pull the “Recoil Starter (pull rope)” (4) to start the engine.
5. Use the “Choke Lever” (6) as needed.
NEVER RUN ENGINE WITH BOTH FUEL SOUCES
TURNED ON!
THREADED CAP MUST BE RE-INSTALLED ON ENGINE CARBURETOR WHEN
REMOVING PROPANE FUEL SOURCE!
8
FOR FURTHER INFORMATION SEE ENGINE OWNERS MANUAL SUPPLEMENT