8.
Installing the soap dispenser:
Insert the soap assembly (I) through the
selected hole in the sink. Secure the soap
assembly to the sink with the soap dispenser
quick install nut (J) provided. Pushup the quick
install nut (J) to sink and hand-turn to tighten
.
From under the sink, screw the soap bottle (K)
onto the soap assembly (I) shank. Insert the
soap pump (H) down into the soap assembly (I).
8
H
I
K
J
Sink
Sink
Push
up
Screw
6.
Drill a hole in the wall using a 6 mm (15/64 in.) diamater
drill bit. Install the battery pack (M) using the molly
anchor (1) and screw (2) provided. Insert the battery
pack cable (3) into the control box connection (4).
NOTE:
After installing the battery pack, the light on the
sensor will flash and the faucet control box will make
a "click" sound when you move your hand in the sensor
area. If not, check to ensure the batteries are installed
correctly.
7.
Install the weight clip (G) at the point of the hose (1)
marking “weight here”. Insert the weight (F) onto the
clip (G) by sliding it down onto the clip (G).
ASSEMBLY INSTRUCTIONS
7
6
7
(15/64 in.) dia.
6mm
1
2
4
3
M
1
2
Weight
here
Weight
here
F
F
G
G
1
L
J