Allen-Bradley PowerFlex 527, User Manual

Page: 51 / 176

Rockwell Automation Publication 520-UM002B-EN-E - December 2017 51
Chapter
3
Configuring the PowerFlex 527 Drive with
Integrated Motion
This chapter procedures on how to set up Integrated Motion on the EtherNet/IP
network control by using a PowerFlex® 527 Drive.
Configure the Drive You can include the drive in your Studio 5000 Logix Designer® application by
adding it to a configured EtherNet/IP module or controller and adding it under
the I/O configuration tree. After setting the network configuration, you can view
the drive status information in Studio 5000® software and use it in your
Studio 5000 Logix Designer application.
Set the Network Configuration
You can set the network configuration by using the LCD display and drive
keypad.
1. When the LCD display is showing the Device/Axis state, use the keypad
to navigate to SETTINGS -> NETWORK. Then choose either STATIC
IP or DHCP.
The default setting is STATIC IP.
2. If you chose STATIC IP, then you must configure the following settings:
•
IP address
• Gateway
• Subnet mask
For information on... See page...
Configure the Drive 51
Configure the Logix Designer Application Project 52
Add a PowerFlex 527 Drive 57
Configure the PowerFlex 527 Drive 59
Apply Power to the PowerFlex 527 Drive 82
Test and Tune the Axes – Velocity and Position Control Modes 83
TIP
Before you begin, make sure you know the catalog number for each drive
component, the Logix module and /or controller used in your motion control
application.