Publication 1766-RM001A-EN-P - October 2008
Communications Instructions
449
Select DHRIO Routing Table tab. If no routing table has been created the
following should appear.
Right click on the Backplane and left click on Edit Module. Make sure that
the Back plane Link ID is set to 20.
Right click on the 1756-DHRIO module and left click on Edit Module.
Make sure that CH A's Link ID is set for 7 and CH B's Link ID is set for 2.
Select OK. Channel B is actually not necessary.
Right click on the Backplane and left click on Add Module. Left click on
1756-ENET.
Enter the correct slot number 2 and Link ID 16 for the ENET module.
Right click on the 1756-ENET Link ID and left click on Add Module. Left
click on AB PLC.
Enter the IP address (100.100.115.1) for the destination Ethernet processor
and its Link ID (24).
The Configuration should now look like the following.
efesotomasyon.com - Allen Bradley,Rockwell,plc,servo,drive
