Rockwell Automation Publication VIEW-IN002C-EN-P - October 2018
5
Adapter Kit for PanelView 5000 and PanelView Plus 7 Performance Terminals
3.
Cut out the center white space and the white edges of the drill template, and leave the
shaded part of the template that includes the drill locations.
4.
Center the drill template over the existing cutout in the panel.
Align the edge of the existing panel cutout with the interior edge of the drill template.
5.
Use the masking tape to secure the drill template to the panel.
6.
Use a center punch to mark the center of the drill locations.
7.
Remove the drill template and masking tape.
8.
Cover and protect components in the enclosure or within the drilling vicinity.
9.
To drill the pilot holes, use the 4.76 mm (3/16 in.) drill bit.
10. To drill the finish holes, use the 6.35 mm (1/4 in.) drill bit.
11. Remove any burrs from the drilled holes.
12. Remove all drill shavings from inside the enclosure and the vicinity.
13. Remove the temporary covers and protection from the enclosure and drilling vicinity.
IMPORTANT
Make sure that the drill template is flat against the panel with no wrinkles or creases
that can distort the drill locations.
ATTENTION:
Make sure that drill shavings do not enter any components that are
installed in the enclosure or in the vicinity. Drill shavings can damage components.
ATTENTION:
Use the shortest possible drill bit that will drill completely through the
panel. Do not drill into any existing components inside the enclosure.
Publication VIEW-DS002B-EN-P - September 2018
Drill Template for PanelView™ 5000 and PanelView Plus 7 Performance Terminals 6.5-in. Keypad with Touch Screen Adapter Kit
Panel
Edge of the Existing
Cutout in the Panel
Edge of the Drill Template
