FLEX Ex Spring Clamp Terminal Base
5
1797-5.2 - September 1999
2. Check to make sure that the 16 pins in the male connector on the
adjacent device are straight and in line so that the mating female
connector on this terminal base unit will mate correctly.
3. Make certain that the female flexbus connector is fully retracted into
the base unit.
4. Position the terminal base over the 35 x 7.5mm DIN rail A
(A-B pt. no. 199-DR1).
!
ATTENTION: Do not force the terminal base into the
adjacent modules. Forcing the units together can bend or break
the hook and allow the units to separate and break
communication over the backplane.
A
A
41114
Position terminal base at a slight angle and
hooked over the top of the DIN rail A.
41115
Slide the terminal base over tight against the adapter (or proceeding terminal
base). Make sure the hook on the terminal base slides under the edge of the
adapter and the flexbus connector is fully retracted.
Allen-Bradley
