6
FLEX Ex Spring Clamp Terminal Base
1797-5.2 - September 1999
5. Rotate the terminal base onto the DIN rail with the top of the rail
hooked under the lip on the rear of the terminal base. Use caution to
make sure that the female flexbus connector does not strike any of
the pins in the mating male connector.
6. For specific wiring information, refer to the installation instructions for
the module you are installing in this terminal base unit.
7. Repeat the above steps to install the next terminal base.
8. Be sure the flexbus connector cover on the last terminal base is in
place.
Wiring
1. Make wiring connections as described in the installation instructions
included with the specific module that mounts on your terminal base
unit.
2. CV and -V from this terminal base unit to the next using
jumpers or individual external wiring, if appropriate due to total
module power consumption.
Press down on the terminal base unit to lock the terminal base on the DIN rail. If
the terminal base does not lock into place, use a screwdriver or similar device to
open the locking tab, press down on the terminal base until flush with the DIN
rail and release the locking tab to lock the base in place.
41116
41117
Gently
push the flexbus connector into the side of the
adapter to complete the backplane connection.