10
Rockwell Automation Publication 1783-IN017A-EN-P - July 2017
ArmorStratix 5700 Ethernet Managed Switches
Confirm Installation
To confirm the installation, power on the switch, and verify that the switch powers up.
The time that is required for the switch to start up is directly related to your switch configuration. Start time is negatively affected by such things as
the following:
• Spanning Tree Learning mode
• Number of files or images in onboard memory
To test the switch, follow these steps.
1. Power on the switch.
If the switch that is directly connected to a DC power source, locate the circuit breaker on the panel board that services the DC circuit, and
move the circuit breaker to the On position.
2. Verify the start-up sequence.
The Setup status indicator blinks green as the IOS software image loads. If the routine fails, the Setup status indicator turns red.
Specifications
IMPORTANT
Start-up failures are usually fatal to the switch. Contact your Rockwell Automation representative immediately if your switch does not complete
the start sequence successfully.
Attribute
1783-ZMS8TA
1783-ZMS16TA
1783-ZMS24TA
1783-ZMS4T4E2TGP,
1783-ZMS4T4E2TGN
1783-ZMS8T8E2TGP,
1783-ZMS8T8E2TGN
Temperature, operating
-40…+60 °C (-40…+140 °F
Temperature, ambient
60 °C (140 °F)
Enclosure type rating
IP66 rated for protection against dust and water jets
IP67 rated for protection against dust and submersion in water
NEMA Type 4
ATTENTION:
The switch is IP66/IP67- and NEMA Type 4-compliant only when all IP66/IP67 cables are mated and torqued appropriately or with the supplied
dust caps attached.
Switch power input rating
12…48V DC, 1.5 A
12…48V DC, 1.8 A
12…48V DC, 2.0 A
PoE/PoE +: 48…54V DC, 2.9 A
Non-PoE: 9.6…60V DC, 2.9 A
PoE/PoE+: 48…54V DC, 3.3 A
Non-PoE: 9.6…60V DC, 3.3 A
Alarm relay rating
—
30V DC, 1.0 A or 48V DC, 0.5 A
Isolation voltage
60 V (continuous), basic insulation type, DC power ports to ground, and PoE power ports to ground
No isolation between individual Ethernet ports
No isolation between PoE Power and Ethernet ports
No isolation between Console port and system
Wire size, ground connection
4.0 mm
2
(12 AWG) min, stranded copper wire
Wire size, power connector for IP67 cable
600V 16 AWG, 105 °C (221 °F)
Wire size, Alarm connector for IP67 cable
—
300V, 22 AWG,105 °C (221 °F)
Torque, ground lug screw
0.4 N•m (3.5 in•lb)
Torque, power ports
0.23 N•m (2.0 in•lb)
Torque, alarm, console, Ethernet ports
(M12 connectors)
0.5…0.8 N•m (4.43…7.08 in•lb) for mating cables or dust caps
Torque, power supply connector
(mini-change)
1.13 N•m (10 in•lb)
Torque, SD card door captive screws
1.8…2.2 N•m (15.93…19.47 in•lb)
Pilot duty rating
Alarm not rated
Operating and storage altitude
Up to 4570 m (15,000 ft)
Dimensions (H x W x D), approx
243.8 x 237.49 x 86.3 mm
9.6 x 9.35 x 3.4 in.
243.8 x 300.99 x 68.07 mm
9.6 x 11.85 x 2.68 in.
243.8 x 374.65 x 68.07 mm
9.6 x 14.75 x 2.68 in.
243.8 x 237.49 x 86.3 mm
9.6 x 9.35 x 3.4 in.
243.8 x 300.99 x 68.07 mm
9.6 x 11.85 x 2.68 in.
Weight
3.26 kg (7.19 lb)
3.30 kg (7.28 lb)
4.02 kg (8.86 lb)
3.26 kg (7.19 lb)
3.30 kg (7.28 lb)
