TRANSPORTATION AND UNPACKING
If the appliance is transported in a horizontal position, the oil from the compressor may leak into the
cooling circuit. For this reason, allow the appliance to rest in a vertical position for 12 hours before
turning it on, so that the oil flows back into the compressor.
Remove the external packaging, remove the protective plastic film from the surface of the appliance
(if used) and clean the external parts of the appliance with a cleaner designed for this purpose. Do
not use steel wool or any coarse agents, which could irreparably damage the surface of the
appliance. Carefully remove all papers and adhesive tape from the appliance, doors and other parts
packed in polystyrene. Remove documents and accessories from inside the appliance.
The packaging material is recyclable and is marked with a recycling symbol. For disposal, follow
the local regulations. Packaging materials (plastic bags, polystyrene parts, etc.) must be kept out of
the reach of children, because they present a possible source of danger.
Carefully inspect the appliance. If you discover any faults, stop the installation and contact the
vendor.
INSTALLATION INSTRUCTIONS
Before installation of your appliance
The placement of the appliance must meet the requirements in the section Operating Conditions on
page 7 and must include a stable floor with a load-bearing capacity corresponding to the weight of
the appliance.
Level the appliance using the adjustable feet. Ensure there is a gap between the bottom edge of
the appliance and the ground, so that there is sufficient circulation of air. This will ensure the optimal
performance of the cooling system.
Check whether any coolant circulation pipes have been damaged during the installation.
Use the appliance only for the purposes for which it has been designed.
The appliance must be located on a rigid and even surface. In this way you will ensure free
circulation of the coolant and effective operation of you appliance.
If possible, place the appliance in a cool, well ventilated and dry room.
Do not locate the appliance in direct sunlight or in a room with a high ambient temperature, or in the
vicinity of any sources of direct heat, such as a radiator or oven. This would cause the compressor
to work harder, resulting in a substantially higher power consumption level.
NOTE: The appliances can be installed as either built-in or free-standing units. For free-standing
installation,
allow at least 4” of clearance at the back, sides and top of the unit to permit the proper
air circulation to cool the compressor and condenser. Even for built-in installation, certain clearances
are necessary for optimal operation. In this case,
allow 3/16” on both sides,2” at the rear and 1/16”
at the top to ensure proper ventilation. Take care that the air vent at the front of the appliance is never
covered or blocked in any way.
