Installation instructions
- Remove the heater from its packaging and remove all packaging material from the device and
its accessories. If you perform a functional test before installation, wait for the unit to cool and
then mount the unit.
- First, carefully select an appropriate area to mount the heater on the wall.
- The heater can only be mounted on the wall using the bracket supplied with the product.
- The direct connection of the heater to the power supply can only be carried out by an
authorized person (electrician).
- Be careful not to damage the water or power lines on the wall during drilling.
Mounting of the heating
- First, test how the brackets hang the heater properly. Measure the hole spacing of the brackets
to size the wall required for mounting.
- When you specify the size distance, place the brackets on the wall to mark the holes to be
drilled in the wall.
- Drill 4 holes in the wall. Be sure to use the correct plugs for the solid walls, hollows, gypsum
walls, etc. Depending on the condition of your wall Use 4 6x80 mm screws and screw the
bracket wall tightly. We recommend that you use the washers so that the screws can be
tightened securely. Now install the heater.
Operating:
1. Connect the power plug to a standard household type 230 V ~ 50 Hz AC socket.
2. With the thermostat, the heating can be switched on and off and the heating power can be
adjusted in three stages.
3. It takes about 10-15 minutes to fully experience the heating and feel the temperature.
Note!
1- The first use may cause odor. This is a design requirement and not an error.
Provide adequate ventilation.
2- If the room is completely cold, the room may take some time to warm up.
Cleaning, maintenance and service
- Turn off the heat and remove the power plug before cleaning. Only clean it when it’s cold. Use a
microfiber cloth to clean and avoid using aggressive cleaning products and scrub pads.
- After cleaning, leave the appliance dry before using it again. Never immerse the appliance in
water. The heater generally does not require maintenance. It should not be opened by
unauthorized people! If you believe that something is not going right, please contact your
dealer.
Service and Repair
- If there is any damage or inconsistency in your heating system, it should only be checked and
repaired by the manufacturer. Any unauthorized repair, modification, improper use, negligence
or improper or inadequate maintenance will void the warranty.
- Dealers and manufacturers are not responsible.
EN