Chapter 7/8
Intentionally left blank.
Chapter 9 Miscellaneous commands
The followings are miscellaneous commands:
l
Restart and Reset commands
l
Display commands
l
Display setting according to the terminal software
9-1 Restart and Reset
9-1-1 RESTART command
Abbrev. RESTART default : none parameter: none
Example: RESTART
This will restart the TNC. If memories are stored, it initializes according to the stored data. This is
used mainly to set parameters such as AWLEN and PARITY which is available only when the
TNC is initialized.
9-1-2 RESET command
Abbrev. RESET default: none parameter: none
Example: RESET
This is used to set all parameters to their default values. Use this command if the TNC is
operating in an erratic manner or if a return to default settings is desired. After using RESET, all
user settings must be re-entered.
9-2 Display the parameter status
9-2-1 Display command
Abbrev. DISP default; none parameter: character as shown below
Example: DISP (display all)
This is used to display the parameter settings in full or in part.
DISP=
displays all parameter settings.
DISP A= displays COM port related parameters.
DISP C=
displays special characters related parameters.
DISP H=
displays hellscounter related parameters.
DISP I=
displays ID related parameters.
DISP L= displays link related parameters.
DISP M=
displays monitor related parameters.
DISP T= displays timing related parameters.
