Alimak ALC II, User Manual

Page: 44 / 62

A
38
Programming ot the movable top landing for a
slipform installation
First check if GROUP 6, VALUE V4 (page A12 – A15) is chosen
before starting the programming of the landings.
Then check that all programmed landings from previous
installations are deleted. Make a new CD drive at this stage.
Program the bottom landing and possible intermediate landings
according to instructions on page A 20 – A 25 , after the
completed CD drive.
Program the movable top landing according to the following.
Press the Prog. button inside the car electrical panel until the
Prog. LED is illuminated. The lift is now in programming mode.
The display show 0 and F5 ( if the bottom landing only is
programmed into the system).
DOL operated lifts
– Run the lift with the Up-button inside the car to the
movable landing at the slipform. Check that the car
electrical switch is actuated by the landing cam at the
slipform (input LED D12:11.4 off).
– Push the Stop Next Landing button on the car CPU. The
system will unlock the doors one by one. Open suitable door
for the landing in question (if not, the landing will be stored
as a closed landing).
The Prog. Led goes out.
VFC operated lifts
– Run the lift with the Up-button inside the car to the movable
landing at the slipform. Check that the car electrical switch
(Ret. and Stop movable top landing) is actuated by the
landing cam at the slipform (input LED D12:11.4:11:5 off).
– Push the Stop Next Landing button on the car CPU. The
system will unlock the doors one by one. Open suitable door
for the landing in question (if not, the landing will be stored
as a closed landing).
The Prog. Led goes out.
ALIMAK 35009 - 1/12
0 and F5 flash alternately
on the display for the single
system.