80...Trim the corners off of the 45 degree cuts made in the last step.
81...Sand the corners of the nose block round and smooth.
Now remove the nose block from the nacelle.
82...Secure the motor mount to the front of the motor with the four flat
head screws. Now bolt the motor to the firewall with 4-40 screws and
aluminum tube spacers.
Mark the nose block and nacelle front so you know which nose block
fits on which nacelle after covering.
83...Re-attach the nose block to the nacelle. Carefully trim the back of
N-9 to clear the motor mount screws if required.
Remove the nose block and motor from the nacelle and set aside until
later.
Repeat steps 59 thru 83 to build the other nacelle.
Building the Wing:
84...Cover the right wing plan with wax paper to prevent the parts from
sticking to the plan.
85...Cut one of the 3/32” x 1/4” x 24” balsa spars into two 12” lengths.
Glue each of these 12” pieces to one of the 3/32” x 1/4” x 24” balsa
spars as shown on the plan.
Page 23
Summary of Contents for C-310-B
Page 4: ...Page 4 W 3 W 3 ...
Page 5: ...Page 5 ...