8
www.Observint.com
© 2017 Observint Technologies. All rights reserved.
13. Check all the HDD cable connectors to verify they are fully seated, and then reinstall the NVR top cover.
14. When powering on the NVR, us the Alibi Wizard to initialize (
Init
) the HDD(s).
8.
While holding the HDD in place, carefully turn over the chassis with the HDD and then tighten the mounting screws to secure the HDD.
Be careful not to overtighten the screws.
HDD 1 mounting screws
9.
Turn the chassis over so the top is up.
10. Attach the SATA data cable that is plugged into the HDD 1 SATA data cable connector to the HDD 1 SATA data connector. When the
connector is fully seated, it clips into place. See the photo below.
11. Plug either HDD power cable connectors into the SATA power cable connector on the HDD.
12. If you are installing a second HDD in the chassis, follow steps 7 through 11 above to position, secure and cable the second HDD in HDD
bay 2. See the photo below.
