Alibaba Cloud SAG-1000, Configuration Manual

Page: 18 / 23

Smart Access Gateway SAG-1000 Configuration Guide / 3 Web configuration
3.4 Step 4: Configure the ports and routes
There are six ports on the SAG-1000 device. Port 0 and Port 1 are SFP optical ports,
and Ports 2-5 are RJ45 electrical ports. You can configure a static route or OSPF routes
for port connection.
Procedure
1. On the Web configuration page, click Port Settings.
2. Configure the ports of the gateway device according to the following information,
and then click OK.
Configuration Description
Connection
method Choose to access the switch using static or dynamic routing.
Notice:
When dual-device one-arm mode is used, only dynamic
routing is supported.
Port Click the Edit option in the Configuration Information area,
enter the IP of the port used for communication and select
whether to enable OSPF.
Port 2 is the default administrator port.
OSPF routing configuration
Area ID
The ID of the area.
Make sure that area IDs of Smart Access Gateway 1 and
Smart Access Gateway 2 are different.
Hello_time The interval at which hello packets are sent, in seconds.
Default value: 3 seconds.
dead_time The dead interval of OSPF neighbor, in seconds. The
neighbor relation stops if no hello packet is received during
the dead time.
Default value: 10 seconds.
Authentication
method Select an authentication method.
• Do not authenticate: Do not perform authentication.
• Clear Text Authentication: Enter a clear text password.
• MD5 Authentication: Use the MD5 method to perform
authentication. Enter the MD5 key ID and the MD5 key.
Routerid The ID of the OSPF router. We recommend that you directly
use the service IP.
10 Issue: 20190228