1.
Rewire Wash Tank Heater Element for 1PH
2.
Locate the wash tank heater mounted on the right side
of the wash tank.
3.
Remove the paper insulator, wires and jumper
bars from the heater terminals.
4.
Additional short jumpers bar are stowed on the
heater terminals.
5.
Reposition the jumper bars for 1PH as shown at right.
6.
Connect the #33 wire to one element terminal as shown.
7.
Connect the #34 and #35 wires to the other terminals as shown.
8.
Reinstall the paper insulator.
16
8. Using the splash shield as a template, mark and drill two holes in the corner post.
Secure the shield to the post using the 10-32 screws, nuts and washers provided in the kit.
9. Open and close the doors to ensure there is no interference between the doors and shield.
10. Turn the dishwasher power on to fill the dishwasher.
11. The installation is complete.
Fig. 7
APPENDIX A
: Installing DH6000T Corner Splash Shield Kit P/N 901114
