Manual
Timy3 – Safe Driving 2
- 8 -
3 Program “Save Driving 2”
The "SAFE-DRIVING 2" program is used for safe driving training. The speed at a certain point
is measured. Arrows, stop lights or a brake light indicate how the driver should react.
............evasive manoeuvre to the left
............evasive manoeuvre to the right
Left Side .....obstacle left, swerve to the right
Right Side ...Obstacle left, swerve to the left
....................break
When channel C0 (first photocell) is triggered, the white brake signal (white dot) appears im-
mediately on the display panel (delay adjustable). After the set delay, the other signals are
displayed. If the speed measurement (SPEED) is activated, the speed measurement starts
and appears in the Timy3 display <Speed = ---.->.
If channel C1 (second photocell) is triggered, the speed will appear on the display panel after
the set delay. If the pulse from C1 is not triggered within 10 seconds after C0, the measurement
is aborted.
The speed is shown on the display board 1. A breaking light (white), two direction arrows
(green) and two stop lights (red) are shown on display board 2 (lower display).
If the direction arrows or stop lights show up, additionally the breaking light goes on.
From the four symbols (
) comes up, only one of these will be shining,
but always together with the breaking light.
Summary of Contents for Timy3
Page 1: ...Version E220704 Manual Safe Driving 2 ...
Page 7: ...Manual TIMY3 Safe Driving 2 7 2 Setup of the System ...
Page 13: ...Manual TIMY3 Safe Driving 2 13 4 2 Display Board Connections ...
Page 14: ...Manual Timy3 Safe Driving 2 14 4 3 Mounting of the Display Board ...