TED-TX / RX
Page 13
Version: E-2000-03-02
Page 13
3.4. Address:
The code-switch (9) to address the TED is located in the
bottom and has 16 switch positions. Within a system all
TED-TX and TED-RX need the same address.
Together with the TED you will receive a
small screwdriver. It is used to operate
the code-switch (9) and (12). The arrow
of the switch shows always the switch
position. The factory adjustment is 0.
If different ALGE TED-systems are used in the same area, it is important that every system works
on a different address. The address protects from wrong impulses or data, but other impulse or data
strings can block the receiver.
There is the possibility that you could lose an impulse, if there is another system in use that has a
stronger signal. The only guaranteed way to prevent interferance is by using a totally separate
frequency. This can be ordered by your ALGE dealer.
e.g. Impulse transmission of the start signal::
You must set the same address for TED-TX and TED-RX.
Code-Switch (9)
Address
switch position = 0
address = 0
switch position = 1
address = 1
switch position = 2
address = 2
switch position = 3
address = 3
switch position = 4
address = 4
switch position = 5
address = 5
switch position = 6
address = 6
switch position = 7
address = 7
switch position = 8
address = 8
switch position = 9
address = 9
switch position = A
address = A
switch position = B
address = B
switch position = C
address = C
switch position = D
address = D
switch position = E
address = E
switch position = F
address = F