Alfresco VERSAPOWER, User Manual

Page: 6 / 20

6
LOCATING AND ASSEMBLING THE UNIT:
When determining a suitable location for your VERSAPOWER™ Cooking System, take into account
concerns such as exposure to wind, rain, sprinklers, proximity to traffic paths and keeping any gas sup-
ply line runs as short as possible.
Locate the unit only in a well-ventilated area. Never locate the grill in a building, garage, breezeway,
shed or other such enclosed areas without an approved ventilation system. Never locate the unit over,
under or next to unprotected combustible construction. During heavy use, the unit might produce a lot of
smoke.
CLEARANCES:
TO NON-COMBUSTIBLE CONTRUCTIONS:
A minimum of 3” clearance from the back and sides of the unit to non-combustible construction is re-
quired to allow the heat to escape if large diameter pots are used.
TO COMBUSTIBLE CONTRUCTIONS:
This appliance can be located on top of combustible construction as tested according to ANSI Standard
Z21.58-2007 Section 2.20, but anything above [and including] the countertop must be made of non
-combustible materials. A minimum of 3” clearance from the back and sides of the unit to non-
combustible construction is required to allow the heat to escape if large diameter pots are used.
ASSEMBLY:
Before locating your ALFRESCO™ VERSAPOWER™ Cooking System into your Non-Combustible en-
closure, complete the following steps:
1. Remove all packaging materials.
2. Ensure that the burners are positioned correctly on their orifices,
3. Position the burner grates on their location.
4. Ensure that new batteries are fitted and the igniter cap is properly installed. See Battery
installations instructions on next page.
5. Make the connection to the gas regulator according to the instructions on pages 7, 8 & 9
for your gas type.
6. To comply with safety and service requirements, main gas shut off valve must be accessi-
ble from front of unit without using any tools.
BATTERY INSTALLATION:
To install a new 9 Volt igniter battery please follow these steps:
1. The igniter module is located behind the front panel and is accessed by opening and re-
moving the grease tray.
2. Locate the igniter module, unscrew the round black cap and install a new 9V battery into
the cap.
3. Reinstall cap into the module, tightening the cap completely.
4. Re-install the grease tray and close it completely by pushing forward until it stops.
NOTE: The VERSAPOWER™ Cooking System has only one igniter module in the center of the
unit that operates both burners. (see figure # 1).