16
BURNER CLEANING:
Clean the exterior of the burner with a brass wire brush. Clear any stubborn scale with a metal scraper.
Clear any clogged ports with a thin wire. Never use a wooden toothpick as it may break off and clog the
port. Shake out any debris through the air shutter. Use a flashlight to inspect the burner inlet to ensure it
is not blocked, if obstructions can be seen, use a stiff wire to clean out the burner throat.
ORIFICE CLEANING:
Remove the orifice and shine a flashlight through the openings to ensure there is no blockage. Use a
needle to clear any debris. Be extremely careful not to enlarge the hole or break off the needle.
TO REASSEMBLE THE BURNERS:
Replace the burner by sliding the air shutter over the brass orifice, centering it in the hole and resting the
rear of the burner onto its supporting bracket.
ELECTRODE GAPS:
The right gap must be maintained to ensure a proper spark. The gap should be 1/8” to 3/16”. To adjust
gap, hold the base of the wire rod tightly with a pair of pliers, and with another set of pliers, twist the tip
of the wire to achieve the correct gap. Igniter batteries should be replaced at least once a year, following
the instructions on page 7.
NOTE:
Rough handling of the electrode can crack the ceramic body, causing all of the igniters to fail.
Light all of the burners and check for proper flame characteristics.
ADDITIONAL CONSIDERATIONS:
Always keep the area around the unit free of obstructions and debris. Maintain at least 3” of space
around unit to ensure proper airflow, and keep all ventilation openings clear and free of debris. Visually
check flame characteristics and compare to description on page 13. Adjust if needed. Clean appliance
after each use, and check for blockages, especially at the burner orifices, after periods of prolonged non-
use. To maintain the appearance of your ALFRESCO™ VERSAPOWER™ Cooking System for many
years, keep it covered when not in use. Backyard environments are harsh on your units’ finish. Long ex-
posure to sun, water, yard chemicals and the elements will reduce the appearance of the stainless steel.
This is especially applicable in ocean front locations, or locations subject to sea mists. ALFRESCO™
strongly recommends that you cover your unit when not in use.
TROUBLESHOOTING:
BEFORE CALLING FOR SERVICE:
If your ALFRESCO™ VERSAPOWER™ Cooking System does not function properly use the following
checklist before contacting your dealer for service. You may save the cost of a service call and the in-
convenience of being without your unit. Additional troubleshooting tips can be found on our website at
www.alfrescogrills.com.
SPIDER AND INSECT WARNING:
Spiders and insects can nest in the burners of this or any other unit, and cause the gas to flow from the
bottom of the burner. This is a very dangerous condition, which can cause a fire to occur behind the
valve panel, thereby damaging the grill and making it unsafe to operate.
WHEN TO LOOK FOR SPIDERS:
You should inspect the burners of this unit at least twice a year or immediately if any of the following
conditions occur:
Summary of Contents for VERSAPOWER
Page 1: ......
Page 2: ...2 PASTE SERIAL NUMBER LABEL IN THIS LOCATION NOTES VERSAPOWER SERIAL NUMBER LABEL ...
Page 20: ......
