14
Cutter Head 45 ° and radius 2,5
Cutter Head only for 30°
For very quiet operation and high stock-removing capacity the device has been equipped with triple milling
heads, with 3 cutting inserts each. These cutting inserts have 3 cutting edges. They are the actual tools for
bevelling and deburring. Depending on the material they can be used for machining steel, aluminium,
aluminium alloys and plastics.
Suitable for machining chamfers of
45° and radius R 2,5
only for 30°
(Prod.-No. 25202)
(Prod.-No. 25203)
Cutting inserts seize: 13,47 x 3mm / PM25 M coated .
Cutter Head with Radius 2,5 Cutting Insert
For bevelling and deburring, use the 2.5 mm radius cutter head, Prod.-No. 25202
together with the cutting insert Prod.-No. 25205.
Suitable for steel of up to 600N/mm²
Note: When inserting the milling head with radius, the supporting plate must be rotated to achieve the correct
position (compare 4.1).
Prior to machining steel and aluminium or aluminium alloys, it is recommended to spray the cutting edges
with cutting oil-adhesive-foam spotty in order to achieve enhanced machine ability of the edges and higher
durability of the cutting inserts.
Working with the KFK Deburring Device
The motor has a speed governor which can be used to adjust the speed to the relevant material. Infinitely
variable from 6,000 to 10,000 min
-1
.
The ON/OFF switch is located on the handle.
Do not start working on the job until the correct speed has been reached.
Work on material.
When bevelling or deburring, the device must always be guided from left to right (up-cut
milling).
Operation with the device in all positions must be carried out with both hands.
Summary of Contents for 25200
Page 23: ...23 ...