Alfawise U30 Pro, Operating Instruction

Page: 36 / 47

33
Layer thickness
：
0.1~0.4mm available. 0.1mm high precision but long printing time, 0.4mm low
precision but printing time is too short, in general select 0.2mm.
Shell thickness: 0.4mm is very thin, in general select 1.2mm,that will increase printing time.
Enable retraction : To prevent the wire from leaking when printing quickly, otherwise it will affect
the appearance.
Bottom/Top thickness : In order to make the top layer print more perfect and flat bottom layer.
Fill density : If the intensity is not high, select 20%. If the intensity is high, increase it and the
printing time also will increase.
Print speed : Generally set 30-100, he print speed is higher and the precision is lower.
Printing temperature: Depends on the filament, generally select 190 ~ 210 degrees.
Support type : Include half-support and full support. In general the model with suspended
structure needs to set support, but surface will be rough after removing support.
Platform adhesion type : "None" means do not set any support, "Brim" increases the bottom
area. "Raft" base makes the model more adherent. To make the model better adhere to the base,
add a base or edge. But best to increase a base and a edge relative to the small bottom area.
Diameter : 1.75mm
Flow : 100%