ALFATRON ALF-12X-NDIC, ALF-20X-NDIC and ALF-30X-NDIC
11
3.1 Video Output
3.1.1 Power-On Initial Configuration
Connecting the power, camera will have initial configuration, R indicator light will be flashing. When the camera return to the
HOME position (middle position for P/T), and lens finish zoom in/out, the auto-testing is finished. IR led will also stop
flashing. If the preset 0 is set, camera will rotate to the 0-preset position after initial configuration.
3.1.2 Video Output
Connect to the video output cable: the user selects the output mode.
1) network output: connect this product and your computer through the network cable, then open the browser, enter the
camera IP address (factory default 192.168.5.163) in the address bar, then to the login page and input a user name
and password (factory default are “admin”) ,Finally enter the preview page, and the image comes out.
(Note: If you forget your username, password, IP address, you can manually restore the default by the remote
controller key combination * #)
2)3G-SDI output or (HDMI) output: Connect the monitor with the corresponding video output interface, then the monitor
output image.
3.2 Remote Controller
3.2.1 Keys Instruction
1. Standby Key
After 3S long press, the camera will step into standby mode. Long press 3S again, the
camera will self-test again and back to HOME position. (Note: If power-on mode is turned on
and Preset 0 is set, and there is no operation within 12s, it will automatically point to the
specified preset position.
2. Camera Address Selection
Select the camera
address
which wants to be controlled
3. Number Key
Set or run 0-9 presets
4, *, # Key
Key combination use
5. Focus Control Key
Auto Focus: Enter auto focus mode.
Manual Focus: The camera focus mode is manual
Switch the camera focus mode to manual focus by pressing [focus +] or [focus -] to adjust.
6. Zoom Control Key
Zoom
＋
: Lens near
Zoom
－
: Lens far
7. Set or Clear Preset key:
Set Preset: Set preset key + 0-9 number key:
Clear Preset key: Clear preset key + 0-9 number key
8. Pan/Tilt Control Key
Press Key: Up
Press Key: Down
Press
Key: Left
Press
Key: Right
“HOME” Key: Return to the middle position or enter the next level menu
9. BLC Control Key
Back Light ON / OFF: Turn on or off the back light
10. Menu Setting
Open or close the OSD menu
Enter / exit the OSD menu or return to the previous menu.
11. Camera IR Remote Control Address Setting
【
*
】
+
【＃】
+
【
F1
】
:Camera Address No.1
【
*
】
+
【＃】
+
【
F2
】
:Camera Address No. 2
