Then that will bring you to your high temperature target for
Temp 1. Using the
right button
you will now set the high
Temp target for Temp 1.
Left button
sets and brings you to low temperature setting
for Temp 2. Repeat same steps
Press the
left button
to pass to the next menu.
Tip: During practice you should have your 1st alarm LED
on until you pass your low temp then both LEDS flash
when you reach your max. temp.
Press the
right button
to choose the number of strokes
(Tip: for karts 2 cycle ignition or 4 cycle Briggs & Honda's
always use x 1)
Press the
left button
to pass to the next menu.
By pressing the
right button
, this feature allows the driver
a delay, giving him time, while driving, to watch the RPM
peak. He can choose between 0.4 and 4.4.
With increments of 0.4 .
At 0.4 there is no delay, you will be on dynamic mode.
By increasing the increments it allows him greater time to
see his peak data.
Press the
left button
to pass to the next menu.
Press the
right button
to choose the first LED (wait for
arrows up
and
down
), choose the desired RPM, press the
left button
to set.This brings you to the next LED .
Repeat same steps for each LED .
Press the
left button
to pass to the next menu.
Toll Free:1 (877) 462-7296
www.Alfano-usa.com
9
LOW / HIGH TEMPERATURE ALARM
(Continue)
ENGINE CYCLE for RPM READING
DISPLAY TIME DELAY
SHIFT LIGHTS
