Alfain PEGAS 200, Operating Manual

Page: 12 / 16

-12-
ALFA IN a.s. © www.alfain.eu
Level of wear of the of
tungsten electrode
Smaller Bigger
7.3 REMOTE CONTROL
The PEGAS 200 AC/DC PULSE supports three kinds of remote controls.
1. TIG torch with UP-DOWN buttons
2. Foot pedal
3. Standard separate remote control for changing the value of the welding
current.
All three models of remote controls can be connected by means of the front
panel connector
43 .
Fig . 2 Foot pedal remote control
Pos. Description
P1 Stepping surface
P2 Potentiometer of setting the limit of maximal welding current
P3 Connector (connect to matching connector 13 on the front panel)
When you connect the P3 connector to matching connector on the front panel
43 the function setting the current from the front panel will blocked, instead of
that the max. current is limited by the potentiometer P2 .
By pressing the stepping surface down you start the welding process. The
value of the welding current depends on the level of pressing the stepping
surface. To reach the maximal current limited by potentiometer
P2 requires to
gently pressing to the lowest position of the stepping surface P1 . The set
current will be displayed on the current display 3 .
The welding process ends after releasing the stepping surface P1 .