Alfa Laval LeviMag, Instruction Manual, Page: 11 / 68

3 Installation
The instruction manual is part of the delivery.
Study the instructions carefully and pay special attention to the warnings!
The mixer is for permanent fastening.
Make sure that the motor corresponds to the environment.
Always read the manual thoroughly.
Only install this mixer in mounting angle according to the name plate – see section 2.5 Unpacking/delivery.
Always use lifting equipment when handling the mixer - see section 2.5 Unpacking/delivery.
Always have safety elements removed by authorized personnel.
Never cover or remove the name plate.
!
Never connect to power supply during installation or service.
Always have the mixer connected to power supply by authorized personnel.
Install the mixer in following order of assembly:
Step 1 A Impeller
Weld plate - see section 3.1 Weld plate. B Male bearing
C Weld plate
Step 2 D Drive Unit
Male bearing - see section 3.2 Male bearing.
Step 3
Impeller - see section 3.3 Impeller.
Step 4
Drive Unit – see section 3.4 Drive Unit - WP50 and section
3.5 Drive Unit - WP81.
4307-0016
A
B
C
D
NOTE
Before installing any parts, make sure the tank is clean – rinse thoroughly with clean water and secure that no particles are
magnetized onto any surfaces.
Tools used in the sections are optionally available - see section 10.6 Tools.
Spare Parts and tools for Alfa Laval LeviMag
®
can also be found in the Spare Part list.
3.1 Weld plate
Follow the guide in "Welding guidelines for Alfa Laval LeviMag
®
" for welding of the weld plate into the tank.
CAUTION
Only use authorized personnel to weld in the weld plate.
Alfa Laval cannot be held responsible for incorrect installation.
11