8 Appendix
Ensure totally clean surfaces during mounting. Always use original Alfa Laval parts.
Product information
Klübersynth UH1 6 oils
Synthetic gear and high-temperature oils for the
food-processing and pharmaceutical industries
Klübersynth UH1 6-100, 150, 220, 320, 460, 680, en
Edition
12.09,
replaces
edition
07.09
article number: 096094, 096058, 096059, 096063, 096060, 096064
MA-TM/HSi
Klübersynth UH1 6 oils achieve a particularly
low wear intensity according to DIN 3996
(calculation of load capacity).
Klübersynth UH1 6 oils can also be used for the
lubrication of lifting, drive and transport chains.
Application notes
Klübersynth UH1 6 oils can be applied by
immersion, immersion/circulation and injection.
Klübersynth UH1 6 oils are
not
miscible with
mineral oils and synthetic hydrocarbons like
polyalphaolefins.
Application notes
We recommend cleaning the lubrication points
or rinsing gears with the Klübersynth UH1 6 oil
which will be used after conversion.
Klübersynth UH1 6 oils are neutral towards
ferrous metals and almost all nonferrous
metals.
There may be increased wear when the contact
surfaces of design elements made of aluminium
or aluminium alloys are exposed to dynamic
loads. If necessary, preliminary tests should be
carried out.
For permanent temperatures up to 80°C seals
made of 72 NBR 902 may be used. For higher
temperatures, we recommend to use seals
made of 75 FKM 585.
It should be noted that elastomers from one or
several manufacturers can behave differently.
When applying Klübersynth UH1 6 oils we
recommend the use of two-component paints
(reaction paints) for interior coating. Oil gauge
glasses should preferably be made of natural
glass or polyamide materials. Other transparent
plastics, e.g. Plexiglas, have a tendency to
crack under stress.
The suitability of materials used in contact with
Klübersynth UH1 6 oils should be tested,
especially prior to series application.
Viscosity selection
When determining the oil viscosity for gears,
the manufacturer's instructions take priority.
Only in cases where there are no gear
manufacturer's instructions, the viscosity can be
selected in accordance with the enclosed
worksheet "Klübersynth UH1 6 oils – selection
of oil viscosity for gears".
To determine the correct oil viscosity for
bearings, please observe the bearing
manufacturer's instructions.
For determining the existing viscosity, please
refer to the enclosed viscosity-temperature
diagram indicating the differing viscosity-
temperature behavior of Klübersynth UH1 6 oils
as compared to mineral oils.
Minimum shelf life
The minimum shelf life is approx. 36 months if
the product is stored in its unopened original
container in a dry, frost-free place.
Pack sizes
20 l canister
200 l drum
Material Safety Data Sheets
Material safety data sheets can be downloaded
or requested via our website www.klueber.com.
You may also obtain them through your contact
person at Klüber Lubrication.
51
Summary of Contents for ALTB-SB-30
Page 1: ...ESE03057 EN5 2018 08 Original manual Instruction Manual ALTB SB 30...
Page 2: ......
Page 79: ...79...
