6 Setup diagram
Unsafe practices and other important information are emphasized in this manual.
Warnings are emphasized by means of special signs. All warnings in the manual are summarized on this page.
Pay special attention to the instructions below so that severe personal injury or damage to the top unit are avoided.
6.1
ThinkTop
®
setup utilising IR keypad
General
Flashing LED means no value set. Steady LED means value set as shown.
Default:
Step 2, factory-set tolerance band +/- 5 mm
Step 3-8, disabled
D LED:
Active during set-up:
Flashing in step 1
Steady in all other steps
Or during operations, error condition:
Steady showing hardware fault, indication pin out of range
Flashing showing software fault
Timeout:
A 60 sec. timeout is started as soon as any button(s) are released
On timeout the setup is exited with no changes saved
IR Keypad:
Remote distance 0-300 mm to ThinkTop
®
Symbols
X
Push key on IR keypad with the same number
Simple representation of LED indication:
Yellow
B
IR-Reciver
Red
D
Steady LED
Yellow
C
Green
E
Orange
F
Yellow
A
Flashing LED
General commands in each step (except step 1):
0
Next step / skip step
(In step 3-6 the program automatically moves to the next step
when a position is stored)
5
Clear / disable step
(In step 2 this resets the unit and sets the step 2-8 to default)
(The command is accepted when all unit LED’s flash briefly)
It is recommended to reset the unit before
performing a setup.
Always check for correct signals after the setup.
18
