Dimensions:
80x61x23mm
45x15mm External panel
Weight:
71gr with external panel
Operating Voltage:
from 6V to 8,4V
Power surce:
2x 2S LiPoli 7,4V
Current drain in ON state:
50mA
Current drain in OFF state:
95uA
(500mA after 6 months unused)
Output1 voltage programmable: from 5v to 7.4V 20A peak
Output2 voltage programmable: from 5v to 7.4V 20A peak
Warking temperature:
-10° up to +60°C
These specifications may be changed without advance notice.
SPECIFICATIONS
WARNINGS
ATTENTION:
Use only batteries of type Li.Poli 2s 7,4V
Pay attention not to invert polarity of the batteries
- Pay maximum attention to connector polarity, both on the side of inputs BAT1 and BAT2 and of outputs OUT1 and OUT2
Inversion of polarity damages the Double Voltage and/or the devices connected to it.
- Don't cause short circuits on the outputs of the Double Voltage ; short circuits, even short ones, may cause hard damages.
- Overtemperature may damage the Double Voltage; be sure that heatsinks receive adequate aeration (follow instructions at th
paragraph “Fixing”).
- In order to have a safe fixing, use only the material provided without modifing instructions of the paragraph “Fixing”.
- If you won’t be using the device for more than one week, disconnect both batteries.
This is not a toy.
Pay close attention to the following points, as the non
observance of them can destroy the product, nullify your
warranty and lead to property damages or personal severe
injuries!
- Never leave the product unattended while it is switched on, in
use or connected with a power supply. If a defect occurs, it
could set fire to the product or to the surroundings.
- Avoid incorrect connections or connections with reversed
polarity.
- All wires and connections have to be well insulated. Short-
circuits might destroy the product.
- Never allow this product or other electronic components to
come into contact with water, oil, fuels or other conductor liquids,
as these could contain minerals, which are harmful for electronic
circuits. If this happens, stop the use of your product immediately
and let it dry carefully.
- Always wire up all the parts of the equipment carefully. If any of
the connections loosens, due to vibrations, you might damage
your device.
- Never cut off or modify the original plugs
- Never change the polarity of the receiver connectors
- Do not open the product and never solder on the PCB
WARNING
At the end of its life cycle this product is subject to special
waste disposal and it cannot be disposed with urban
waste
WASTE DISPOSAL
Summary of Contents for DoubleVoltage
Page 6: ...EXAMPLE OK KO EXAMPLE ...
Page 7: ...OK KO EXAMPLE EXAMPLE ...
