6
Features
Important:
When using two Elevate 6 monitors, make sure the
Volume
knob,
HF Trim
switch,
and
LF Trim
switch are in
the same position on both monitors
.
1.
Tweeter:
This driver outputs the audio signal's high
frequencies.
2.
Woofer:
This driver outputs the audio signal's low
frequencies.
3.
Bass Reflex Port:
These ports discharge very-low-
frequency signals to enhance the monitor's overall bass
response. Make sure these ports are not obstructed.
4.
Power Input:
Use a standard IEC cable (included) to
connect this to a power outlet.
5.
Power Switch:
Use this switch to power the monitor on
or off.
6.
Inputs:
Connect your audio interface, mixer, etc. to
either of these inputs:
•
the XLR input, using a standard XLR cable
•
the 1/4" (6.35mm) TRS input, using a standard 1/4"
(6.35mm) TRS or TS cable
•
the RCA input, using a standard RCA cable
7.
Volume:
Use this knob to adjust the monitor's volume. If
you are using two Elevate 6 monitors, make sure this
knob's setting is identical on both monitors.
8.
HF Trim:
Use this switch to slightly boost or attenuate
(reduce) the monitor's high-frequency response above 3
kHz:
•
0dB:
This default setting leaves high-frequency
signals unaffected; nothing is boosted or
attenuated.
•
+2dB:
This setting boosts signals above 3 kHz by 2
dB.
•
-2dB:
This setting attenuates signals above 3 kHz
by 2 dB.
See
Setup: Acoustic Compensation
to learn how to
determine the optimal setting for this switch.
9.
LF Trim:
Use this switch to slightly boost or attenuate
(reduce) the monitor's low-frequency response below
500 Hz:
•
0dB:
This default setting leaves low-frequency signals unaffected; nothing is
boosted or attenuated.
•
+2dB:
This setting boosts signals below 500 Hz by 2 dB.
•
-2dB:
This setting attenuates signals below 500 Hz by 2 dB.
See
Setup: Acoustic Compensation
to learn how to determine the optimal setting for
this switch.
4
5
8 9
7
6
1
2
3
3
Summary of Contents for Elevate 6
Page 2: ......
Page 24: ...alesis com Manual Version 1 0...
