Aleratec 1:11 HDD Copy Cruiser IDE/SATA, User Manual

Page: 52 / 58

www.aleratec.com 46
Specifications
Power Requirements 115 - 230 VAC Switchable
Dimensions
(depth x width x height)
D: 457.2mm W: 177.8mm H: 438.2mm
(7” x 17.25” x 18”)
Weight 14.02 Kilograms (30.9 Lbs.)
Note: Specifications subject to change without notice.
Troubleshooting
If your 1:11 HDD Copy Cruiser is not performing as expected, refer to the
symptoms below, and follow the suggested corrective action.
Symptoms Corrective Actions
LCD Display If the LCD display does not display any message and the
backlight is not lit after powering on the 1:11 HDD Copy
Cruiser, check that the power cable is properly connected
and that the ON/OFF switch is turned on.
Error Messages While the system is performing an operation and the
operation is manually terminated, an error message will
be shown in the LCD display. This may lead to an failed
operation and could cause the 1:11 HDD Copy Cruiser to
stop responding. If this happens, power the unit off, wait
about ten (10) seconds, and then reapply power.
Hard Disk If the 1:11 HDD Copy Cruiser does not detect one of the
hard disk drives, verify that the drive is properly seated in
the drive bay.
Keypad Buttons If pressing the keys on the front panel produces no
response from the system, the 1:11 HDD Copy Cruiser
may still be busy with the previous operation. If the system
idle, power the unit off, wait about ten (10) seconds, and
then reapply power.
Firmware Update The device can be updated to new versions of firmware via
a DVD/CD drive. If unable to update the firmware, check
that the firmware was downloaded correctly. A failed
firmware upgrade may cause the 1:11 HDD Copy Cruiser
to become inoperable. If the system is working normally,
do not attempt this operation. If the system is already
experiencing problems, please contact Aleratec for repairs.
Startup/Shutdown Do not power off the system while it is performing an
operation. After a normal shutdown, wait about ten (10)
seconds before reapplying power.