Alencon BOX -V2
User Manual
22 |
P a g e
6.2.7 Mounting JBOX into BOX Cabinet
The JBOX will be placed in the middle of the rack inside the BOX, above SPOT/BOSS #2
shown in Figure
14
15.
Carefully place the JBOX on the shelf. The shelf is inverted, and there is a lip on the front
that the Box must clear in order to sit flat on the shelf.
Use (6) #10-32 x 1/2" screws to secure the JBOX to the rack through the mounting
brackets (Figure 155).
F
IGURE
15:
JBOX
L
OCATION WITH
M
OUNTING
H
ARDWARE
6.2.8 Connect Power Cables Within BOX Cabinet, from JBOX Front to FEED Units
Depending on the JBOX configuration, wiring of the internal power cables may differ.
All cable whips for internal wiring of the BOX cabinet will be included as additional
hardware with the BOX.
Pre-made cable whips will be labelled on each end as to where they land within the BOX.
JBOX landing terminals are designated by:
o
Internal (A for Alencon) connection OR External (E) connection
o
Location on the JBOX, 1, 2, 3, or 4 for each SPOT/BOSS unit
o
Primary or Secondary connection
o
Positive or negative polarity
F
IGURE
16:
JBOX
L
ABELING
