4
Figure 2
Ball Valve Positions for Modes of Operation
SER 8587-1
Portable Pressurized Oil Drain
Changes Since Last Printing
Part #s 393767-26 and 393767-27
(5-09)
Alemite, LLC
Assembly
NOTE
: See
Page 2
for component iden-
tification on all procedures.
1. Install each Wheel (
20
) onto Tank (
25
).
• Install Washer (
21
) and Screw (
22
) that secures
each Wheel to the Tank.
• Tighten Screws (
22
) securely.
2. Position each Wheel Caster (
30
) onto the Tank.
3. Install Washer (
32
) and Acorn Nut (
31
) that
secures each Wheel Caster to the Tank.
• Tighten each Acorn Nut securely.
4. Install Handle (
23
) into the sockets on the Tank.
• Tighten Screws (
37
) securely.
5. Lubricate O-Rings (
5
) with clean oil.
6. Carefully position the Bowl and Swivel Stem
assembly into the Extension Tube and Swivel
Body assembly.
• Tighten Screw (
8
) securely.
7. Install Strainer (
2
) and Splash Guard (
1
) onto
Bowl (
3
).
8. Position Tool Tray (
24
) onto the Tank’s bracket.
Modes of Operation
Collection
1. Make sure both ball valves are properly
positioned.
• See
Figure 2
.
Position Tube and Bowl Assembly
2. Loosen Hand Wheel (
12
).
3. Raise or lower the Tube and Bowl assembly to the
desired position.
4. Tighten the Hand Wheel.
IMPORTANT: Do not allow the tank to
fill above the highest mark on Level
Gauge (29). An excessive quantity of oil
may cause oil discharge at Air Connec-
tor (18).
Emptying
5. Remove Plug (
27
) from the nozzle on Delivery Hose
Assembly (
26
).
• Position the nozzle into an appropriate collection
container.
6. Make sure that Hand Wheel (
12
) is tight.
7. Make sure both ball valves are positioned properly.
• See
Figure 2
.
CAUTION
Do not exceed 7 psi (0.5 Bar) air pressure when emp-
tying this drain. Damage to components can occur.
8. Set the air supply to a maximum of 7 psi (0.5 Bar).
9. Attach air supply to Connector (
18
).