High-Pressure Material Pump
SER 7889-6
Alemite Corporation
13
Revision (3-03)
11. Slowly supply air pressure to the pump’s motor.
12. Allow the pump to cycle slowly until the product is
once again free of air.
13. Set the air pressure to 100 psi (6.9 Bar).
14. Operate the control valve into the container
momentarily.
15. Shut off the control valve.
• Visually inspect the pump for external leaks.
• The pump should not cycle more than once or
twice in one hour.
If the pump does not stall, refer to the
Troubleshooting Chart
for details.
16. Check the motor for air leakage.
If the motor leaks, refer to the
Air Motor Service
Guide
for details.
IMPORTANT: Make sure to reset the air
pressure to the required operating pres-
sure.
Installation
Additional items that should be incorporated into the air
piping systems are listed in
Table 5
.
* Although the air motor is lubricated at the factory, the
life of the motor can be extended with the use of a lubricator.
Part Number
Description
338862
Moisture Separator/Regulator & Gauge Combination
5608-2
Moisture Separator
7608-B
Regulator and Gauge
5908-2
Lubricator *
Table 5
Air Line Components
