Operation
20
3. Hold the wall bracket on the installation surface and mark
the three locations for fastening.
4. Drill two holes into the wall using a drill
19
and insert the
wall plugs
17
.
5. Screw the wall bracket to the fastening points with the
screws
18
as based on the properties of the installation
surface (see
Fig. C
). Use a cross-head screwdriver
20
for
this purpose. Do not apply excessive force in the process.
6. Slide the solar panel
15
and back cover from above
onto the wall bracket until you hear it click into place
(see
Fig. C
).
7. Completely unfold the charging cable and insert the
plug
14
into the charging slot
9
on the spotlight
7
.
Operation
Configuring the sensor area
1. If necessary, turn the motion sensor housing
10
to reach
the SENS controller
3
.
2. Select the required sensor area:
− Turning the SENS controller clockwise increases the
sensor area range and the motion sensor will already
react from a distance of approx. 12 m.
− Turning the SENS controller anticlockwise decreases
the sensor area range. With the lowest setting, the
motion sensor only reacts starting at a distance of
approx. 1 m.
To further adjust the sensor area, turn the motion sensor
housing
10
. The motion sensor housing can be turned by 90°
(see
Fig. D
). The sensor angle of approx. 110° (+/-10°) does not
change in the process.