Always keep the discharge flap closed when mulching.
- Mow slowly and try not to use the entire cutting width to cut the grass evenly at
high rotation speed. A high cutting load reduces the blade's rotation speed.
- Remove any branches, pegs, stones, strings and mounds (molehills) before
mowing to safeguard the device.
- Always mow in the direction facing away from the power supply and the power
cable.
- Always push the device forward; pulling the device might damage the power
cable.
Adjusting the handle position
The handle can be adjusted to a comfortable working height. Adjust the handle to
your individual working height before working with the device.
1. Undo the two quick-release levers
12
on the handle mount.
2. Set the handle to the desired height.
3. Check whether the serrations of the locking washer engage correctly in the
handle mount
11
.
4. Flick the quick-release levers
3
.
Adjusting the cutting height
You can set the cutting height between approximately 20 and 70 mm. The cutting
height lever
8
can be engaged in 7 positions.
1. Hold the device by the carry handle
7
.
2. Pull the cutting height lever
8
out of its arrester.
3. Slide the cutting height lever
8
to the desired level.
The device lifts or lowers.
4. Engage the cutting height lever
8
properly again.
Preparing for operation
Only use an extension cable if the included cable is insufficient for mowing the entire
lawn. Avoid using more than one extension cable.
1. Check the device, the collecting bag and the blade before connecting the power
supply.
2. Set the desired cutting height before connecting the power supply.
3. Check the handle position and correct it if necessary to work comfortably.
4. Lay out the power cable all along the perimeter of your lawn.
5. Secure the power cable on the pull relief
2
(see Fig. H ).
6. Plug the power cable plug into a properly installed socket.
Operation
14
