Alcorn Mcbride Digital Binloop, User Manual

Page: 104 / 135

Alcorn McBride Binloop User’s Manual Page 94
4. Inside the unit should be:
•
The Power Supply (a silver box on the left side)
• The Controller Card (the card on the left with four
buttons on the lower end and an array of ten LEDs
on the top.
•
Various Audio and/or Video Reproducers - Cards
with one button on the top, an LED right underneath,
and a slot for Compact Flash card(s).
5. Verify the stability of each card (Controller, Audio/Video
Reproducers) to make sure that it has not simply
become disconnected:
• GENTLY push on the card to make sure that is not
off of the tracks in the slot. If it is stable, proceed to
step 7.
6. If the card is not stable:
•
GENTLY pull the card out of the slot.
•
Carefully align the card in between the guides. The
solder side of the circuit board should be facing the
power supply on the left.
•
GENTLY push the card toward the back end of the
unit until you feel the pins lock into place. DO NOT
FORCE THE CARD IN!!!
7. To Remove the Card:
•
Find the card that needs to be replaced.
•
GENTLY pull the card toward you. At first you will
feel some resistance as you pull the card from its
connectors in the back. After the card has been
detached, it will slide easily.
8. Place the card in a Static Shielding bag to protect the
board from static discharge.
9. Place the bagged card on a stable surface.
10. Carefully place the cover back onto the unit. Make sure
that it is facing the right direction (The Alcorn McBride
logo should be right-side up and the buttons should fit
through the holes).
11. Replace the screws and tighten.
12. Pack the card-in-the-bag in a box, padded to protect
against damage.
Please be sure to obtain an RMA number from your distributor (if
outside USA) or from Alcorn McBride before returning product.