ALC2 User’s Manual. Rev. 01
20
6. Connections __________________________________________________
Bridged mono mode
For bridged mono mode, set the lower DIP-switch behind the cover on the front panel to the right hand or ‘ON’ position. Use bridge mode when you want to
combine the power of two amplifier channels into one loudspeaker load. In bridge mode connect your loudspeaker with or without SIS to the channel 1 and
channel 2 outputs as shown above. Connect your signal source to the channel 1 input. In this mode only the channel 1 SDP module can be used. The channel 1
gain control sets the gain for the entire amplifier. Remember, that in bridge mode the amplifier cannot cope with loads lower than 4
Ω
.
