ALCOLOCK LR
8
Using the
ALCOLOCK LR
Connecting the handset
1. Make certain the vehicle engine is off.
2. With the back of the handset facing you,
hold the cable connector with the
“PUSH” button facing you. Align the
cable connector with the receptacle on
the handset and carefully insert.
3. The connector will latch if the pins are
properly aligned.
WARNING! Do not force a misaligned
connector, pull on the cord, or turn the
connector, as doing so may damage the
device.
Disconnecting the handset
1. Make certain the vehicle engine is off.
2. With the back of the handset facing you,
hold the connector by the plug, then
press and hold the “PUSH” button.
3. Gently pull the cable connector to
disengage from the handset.
WARNING! The handset should never be
removed while the vehicle engine is running.
If the handset is disconnected for any
reason while the engine is running, bring the
vehicle to a safe stop off the roadway before
attempting to reconnect the handset.
Performing a breath test
WARNING! DO NOT attempt to switch on the
ignition before providing an accepted breath
sample. Turning the key to the ignition ON
position will cause the handset to display
Turn Key Off and sound a tone which may
result in a violation.
1. Power up the device
by pressing any
navigation button.
The status light will
flash amber. The
handset will display
Wait… until the device
warms up.
2. The status light will
flash green and the
handset will display
Ready for Test.
The warm-up time
may be longer in cold
temperatures.
3. When the handset is ready
for a breath test, insert a new
mouthpiece into the sampling
port on the top of the handset.
Slide the mouthpiece into place
and turn it slightly to secure.
4. Blow moderately
and continuously
into the mouthpiece.
The handset will emit
a continuous tone to
indicate adequate
airflow and will display
Continue Blowing.
If you are not blowing correctly, a
message will appear on the display
indicating the necessary corrective
actions.
DO NOT ATTEMPT another breath
test until the handset displays
Ready for test.
PUSH
PUSH
PUSH
Wait…
Menu
Ready for Test
Continue
Blowing
