10
B4600 Battery-Powered Tool (
HK1189
) Alcoa Fastening Systems & Rings
t
rouBleshootIng
K
Its
anD
a
CCessorIes
Nosepieces:
99-3303L, 99-3305L, 99-3201L
Battery (quick-change): 18.0 V: B-18
Battery charger:
100 V-240 V~/50-60 Hz: CH-18-120-240
1. Tool fails to operate when trigger is pressed:
a. Battery is loose or not connected.
b. Battery is depleted.
2. Pintail stripped and/or swaged collar not ejected
from anvil:
a. Check for broken or worn jaws in nose assembly.
b. Check for worn anvil.
3. Tool overloaded (LED flashes slowly - 1Hz):
a. Check that fastener installation requirements are
within the tool’s work capacity (see page 9).
4. Tool will not return collet to forward position:
a. Check that there is no blockage in the anvil housing
(see page 9).
Always check the simplest possible cause of a malfunction first. For example, a loose or disconnected trigger line. Then
proceed logically, eliminating each possible cause until the defective part is located. Where possible, substitute known good
parts for suspected defective parts. Use Trouble Shooting Chart as an aid for locating and correcting trouble.
a
ttaChIng
anD
r
eMovIng
n
ose
a
sseMBlIes
INSTALLING A NOSE ASSEMBLY
1. Using a 1 inch wrench, remove
Retaining Nut and Anvil
Adapter.
2. Screw Collet onto Spindle
Extension and, using an 9/16
inch wrench to hold Spindle
Extension in place, tighten
Collet using an adjustable
wrench.
3. Slide Anvil Adapter over Collet
and tighten.
4. Slide Anvil into Anvil Holder,
and tighten Retaining Nut using
a 1 inch wrench.
NOTE:
NON-”L” series nose assemblies
can be used by removing the
Nose Spindle Extension first
using a 1/4 inch hex key, and an
adjustable wrench for the Collet.
Do not remove the tool Spindle
Extension.)
Anvil
Insert
Anvil
Holder
Collet
Chuck
Jaws
Follower
Spring
Cap
Anvil
Insert
Anvil
Holder
Collet
Chuck
Jaws
Follower
Spring
Cap
Nose Spindle
Extension
(must be
removed
for use with
this tool)
L series
Nose Assembly
non-L series
Nose Assembly
